RESIMAC


Where only the inner leaf is very soft or perforated masonry materials, the RESIMAC is recommended.This provides an inner screen and tubular body, of length sufficient to rest in the outer Ieaf.A Mac expander is fitted to an M6 stainless steel rod - the original MACBOND wall tie.The threaded end is set in BRC3 resin in the screen and, after the resin is set, the inner leaf connection can be tested and the outer leaf expander set, using a pre-set torque wrench and special hex setting tool.

RESIN CURE TIMES
38 MINUTES AT 25°C
80 MINUTES AT 10°C

 THE BENEFITS
  • Quick and easy to install
  • Corrosion resistant
  • Controlled resin application
  • Manufactured to BS EN ISO 9000
  • Ideal for insulated cavity walls
  • Operator friendly

Catalogue Code No.
Tie Length [mm]
Ms Rod Length [mm]
Cavity Width [mm]
RM6190
125
190
25-45
RM6215
150
215
50-75
RM6240
175
240
75-100

TECHNICAL INFORMATION

  

APPLICATION METHOD

SPECIFICATIONS:
Material A2, 300 series, Austenitic Stainless Steel Nylon screen. PVC Tube Diameters M6 Thread 12mm Expander
TORQUE SETTING:
6.8Nm (51b.ft) ACCESSORIES:
98007 13 x3l0mm S2S drill bit FTSHS Hex Setting Tool TBIOO Fixed HeadTorque Wrench BOPI Blow Out Pump DTE IRIIO DeliveryTube BRHG Resin hand gun
NOTE:
Drill bits to conform to DIN 8035

  
DRILL
Drill I 3mm hole in brickwork, setting depth gauge on drilling machine, to give 75mm hole depth in inner leaf. Blow out inner and outer leaf holes.
INSERT RESIMAC
Place RESIMAC screen/tube over extended delivery tube (DTE I R/I 0 Attached to nozzle) and pass through into inner leaf. Apply BRC3 through delivery tube slowly withdrawing nozzle until it is clear of inner leaf. Insert MACBOND tie.

SET OUTER
Allow time for resin to set before setting Mac expander. Fit hex setting tool on to torque wrench (TB 100) and set Outer expander by tightening nut until pre-set torque is reached. Seal outer brick with colour matching mortar.